|
03-17-2007, 06:06 PM
|
#1 |
|
Registered User
Join Date: Feb 2006
Location: Oklahoma City
Posts: 588
|
2 Questions for ya
1. What did these seats come out of?
2. How hard is it to replace the rag joint? Looks like 2 rivets and 2 bolts. I found a rebuild kit at NAPA for $8 figure it will save me quite a bit of money.
__________________
1970 Chevy C10 "Under Construction"  2002 Chevy S10 V6 
Last edited by st1x10; 03-17-2007 at 06:10 PM. |
|
|
|
03-17-2007, 06:18 PM
|
#2 |
|
sufficiently talented fool
 
Join Date: Jun 2006
Location: Forest Hill, MD
Posts: 2,231
|
Re: 2 Questions for ya
The seats are out of 1988 to 1998 Chevrolet Pickup.
To replace the rag joint, remove the lower pinch bolt and take the lower half of the shaft off of the box. Remove the two nuts and the rag joint. Replace the rag joint, then re install the shaft onto the box.
__________________
"it's impossible to be surrounded by idiots when you are part of the circle"  2003 Suburban 2002 Pontiac Montana 1981 Corvette 1966 Impala Convertible Click here to support the board |
|
|
|
|
03-17-2007, 06:19 PM
|
#3 |
|
Senior Member
Join Date: Jun 2003
Location: Westminster, CO
Posts: 3,071
|
Re: 2 Questions for ya
Those aren't rivets, those just fit in the slots. Two bolts. Pretty easy deal.
__________________
Alex 1971 Lil' Red 350 SBC 700R4 |
|
|
|
|
03-17-2007, 06:31 PM
|
#4 |
|
Registered User
Join Date: Feb 2006
Location: Oklahoma City
Posts: 588
|
Re: 2 Questions for ya
Aight sweet, thanks for all the help guys.
__________________
1970 Chevy C10 "Under Construction" 2002 Chevy S10 V6
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
