|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-24-2007, 02:36 AM
|
#2 |
|
Registered User
Join Date: Jan 2007
Location: Buckeye state
Posts: 168
|
Re: Body Bushing/Mount Replacement
If the back mount bolts break, you can cut holes in the inside of the cab to get to the nuts. On the back ledge behind the seat. Replace then tack weld over the holes you cut.
Front mounts are only in the cab support. You could just cut away enough to get them out and then buy a slip on cab mount and weld it in. Both are worst case scenario's, If PB blaster and heat doesnt work. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode