Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
05-07-2007, 04:20 PM | #11 |
Registered User
Join Date: Aug 2005
Location: Hillsboro Oregon
Posts: 6,449
|
Re: Joined the Short Wheelbase Club *69 Tahoe Project*
Time to lose 20 inches...
I made my cut lines on the inside of the roof because I was able to use one of the roof support members as a guide. I wanted to make the cut as far forward as possible, but also wanted to keep it slightly back from the C-pillar to ease future bodywork/sanding. On the inside I noticed the factory 3-point seatbelt mounts and decided to make the forward cut just behind those. The rear is 20" behind that. You can see here that I cut some wood scraps to use as a guide for the sharpie with the roof member as the fence: After making the cuts from the inside I move to the outside and figured out where to cut based on the previous cuts: ...and there she goes: That thing is heavier than you'd expect; 50-60lbs I think. |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|