lifting the front end... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

79underconstruction · 05-16-2007, 11:45 AM

ok ive looked and looked and i still can not find a lift for the front end of ym truck.. 79 c 10 2 wd 1/2 ton... i am looking for a 4 - 6 inch lift does anyone have any clue where i could find a lift at for it? any help is much appreciated

Prerunner1982 · 05-17-2007, 05:29 PM

3" lift coils are the best "kit" you are going to find. Unless you stumble on some 3" lift spindles by AIM, but I wouldnt trust them. Have you looked into converting to 88-98 spindles as there are 4" lift spindles offered, then you could do 3" coils and 4" spindle.. though you would lose all(most) of your down travel you would have the height you want.

05-16-2007, 11:45 AM	#1
79underconstruction Registered User Join Date: Nov 2006 Location: california Posts: 74	lifting the front end... ok ive looked and looked and i still can not find a lift for the front end of ym truck.. 79 c 10 2 wd 1/2 ton... i am looking for a 4 - 6 inch lift does anyone have any clue where i could find a lift at for it? any help is much appreciated

05-17-2007, 05:29 PM	#2
Prerunner1982 Registered User Join Date: Oct 2002 Location: Edmond, OK Posts: 5,904	Re: lifting the front end... 3" lift coils are the best "kit" you are going to find. Unless you stumble on some 3" lift spindles by AIM, but I wouldnt trust them. Have you looked into converting to 88-98 spindles as there are 4" lift spindles offered, then you could do 3" coils and 4" spindle.. though you would lose all(most) of your down travel you would have the height you want. __________________ Jon 1982 Chevy Silverado 350/th350.... RETIRED 1993 Jeep XJ 2 door(Cherokee) 4wd 4.0ltr/AX-15 (5spd)/NP231 .... Oklahoma Roll Call

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.