|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-10-2007, 11:24 PM
|
#1 |
|
Registered User
Join Date: Jun 2006
Location: fl
Posts: 274
|
any have any problems here and did you fix it
i did a roof and back cab swap and all my measurements are correct but my gap by the pillar goes from 1/2 at bottom to0 at top just wondering if anybody else had this issue and how it was fixed it fit the same before i cut it
|
|
|
|
07-11-2007, 05:32 AM
|
#2 |
|
State of Confusion!
  
Join Date: Jul 2002
Location: Gulfport, MS USA
Posts: 46,842
|
Re: any have any problems here and did you fix it
You might need to shim your door hinge(s) to get the gap closer. They were not that great to begin with. I have seen some do some pulling/manipulation of the window frame to try and even them out also.
How are the rest of the gaps? Top, rear bottom?
__________________
Bill 1970 Chevy Custom/10 LWB Fleetside 2010 Toyota Tacoma PreRunner SR5 Double Cab - DD Member of Louisiana Classic Truck Club (LCTC) Bill's Gallery Life isn't tied with a bow, but it's still a gift. Live simply. Love generously. Care deeply. Speak kindly. Leave the rest to God! Last edited by Palf70Step; 07-11-2007 at 05:33 AM. |
|
|
|
|
07-11-2007, 03:59 PM
|
#3 |
|
Registered User
Join Date: Jun 2006
Location: fl
Posts: 274
|
Re: any have any problems here and did you fix it
the back is nice and i dont have the rocker on yet but the frame looks out of wack i pulled the frame back last night and it looked alot better i wanna try to stay as far away from shims as possible the truck i oringanly bought had like half inch shims
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
