![]() |
![]() |
#1 |
Registered User
Join Date: Jun 2006
Location: fl
Posts: 274
|
drum to disc brake ?
just wondering if all the disc spindles will work on the drum brake control arms
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Aug 2006
Location: Minnesota
Posts: 943
|
Re: drum to disc brake ?
Thats what I did. Should work fine. I went to 73 and up ball joints and spindels on mine.
|
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Jun 2007
Location: Lethbridge, AB
Posts: 234
|
Re: drum to disc brake ?
they just mounted didrectly to your existing drumb control arms? or was it the whole fromt X-member?
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Jun 2006
Location: fl
Posts: 274
|
Re: drum to disc brake ?
read his build i just read it
|
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Aug 2006
Location: Minnesota
Posts: 943
|
Re: drum to disc brake ?
The replacement control arms are the same part # for 67-72 in the lmc catalog. 71-72 came with front disc. You dont need to change the crossmember either.
|
![]() |
![]() |
![]() |
#6 |
Registered User
Join Date: May 2005
Location: PA
Posts: 2,696
|
Re: drum to disc brake ?
The spindles are a direct bolt in. You will lose a little bit of turning radius unless you grind away the stops a little bit though.
The tie rod ends and sleeves are a different story though. Those will not fit. I think there is a thread or 2 floating around with the ones that will make it all work though. |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|