|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-18-2007, 02:13 AM
|
#26 |
|
Senior Member
 
Join Date: Aug 2004
Location: Centennial, CO
Posts: 2,991
|
Re: Frame black, or color matched?
I'm kinda diggin the silver/gun metal/Eastwood "as-cast" finish. That or a flat or semi gloss black. I always thought body-colored frames only looked good on something where the frame has lots of exposure or bodylines like a '32.
__________________
ClusterTruck: 68 C10 Bought in 89, wrecked in 03. Slow low $ rebuild started '17. 6.0 & TKO http://67-72chevytrucks.com/vboard/s...d.php?t=788602 93 K1500 Short Step, 350, NV4500, EBL flash ECU. Vortec heads & roller cam someday... 05 Jeep Wrangler Unlimited. 3” lift & 6-speed 02 E320 the insurance total “free car” 13 Tahoe LTZ |
|
|
|
08-18-2007, 10:11 AM
|
#27 |
|
Senior Member
Join Date: Aug 2006
Location: Minnesota
Posts: 943
|
Re: Frame black, or color matched?
Black!
|
|
|
|
|
08-18-2007, 10:42 AM
|
#28 |
|
PROJECT 7DEUCE
Join Date: Dec 2002
Location: GRANTS PASS OR
Posts: 21,606
|
Re: Frame black, or color matched?
I went with gray on mine at first then changed to black por-15.....
__________________
GO BIG GREEN  GO DUCKSMEMBER #6377 72 k-5 daily driver 6'' lift 35'' 350-350-205 slowly getting rust free. Project "7DEUCE" check out my build http://67-72chevytrucks.com/vboard/s...d.php?t=267665 Tim Powell..R.I.P EastSideLowlife..... R.I.P.. |
|
|
|
|
08-20-2007, 02:42 PM
|
#29 |
|
Tool Addiction=Money Shortage
Join Date: Mar 2006
Location: Grand Forks, ND
Posts: 233
|
Re: Frame black, or color matched?
black please
__________________
1967 K20 400TBI SM465/NP205 posi front, Detroit locker 4.56 rear |
|
|
|
|
08-20-2007, 08:12 PM
|
#30 |
|
Registered User
Join Date: Jun 2006
Location: Paris, TN
Posts: 376
|
Re: Frame black, or color matched?
COLORED!!!! Show attention to detail!!!
|
|
|
|
|
08-20-2007, 08:45 PM
|
#31 |
|
I am a Referee of life.
Join Date: Jun 2000
Location: Greensboro N.C.
Posts: 13,992
|
Re: Frame black, or color matched?
Show truck could get by with colored frame.For a driver or on a truck that gets driven,even if it's only to cruises BLACK.Also keep in mind what you may change later.If you should decide to go to a different body color,that candy red is not going to look very good with a Lime green body.This means tearing down the whole truck.Even if it's going to be a show stopper you may not be able to match the paint if it's a custom mix.JM2CW's
__________________
The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion. You can't fix stupid,not even with duct tape. "My appearance is due to the fact that "GOD" does punish you for having too much fun!" Barrett-Jackson has perfected alchemy,they make rust into gold! "You can lead a horse to water but you can't saddle a duck" "Cleverly disguised as a 'Responsible Adult' "Sometimes your Knight in shining armor is just a retard in tinfoil" |
|
|
|
|
08-21-2007, 12:37 PM
|
#32 |
|
Excelsior, You Fathead.
Join Date: Jun 2004
Location: Valparaiso, In
Posts: 937
|
Re: Frame black, or color matched?
For a driver, I would do black. You can do quick touch ups and it will blend better than a BC/CC paint will. You can get the black in a rattle can for quick touch ups.
__________________
Go Navy. The Sea Is Ours. Budget 350 Build http://67-72chevytrucks.com/vboard/s...38#post2264638 |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
