|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-22-2007, 02:55 PM
|
#1 |
|
Senior Member
Join Date: Apr 2007
Location: East Texas
Posts: 549
|
need drive shaft help!!
i need some help, apparently the drive shaft i got with my truck is to short.
so if possible can someone measure theirs, i got a short bed with a 350/350 2wd thanks
__________________
Justin 1970 c/10 short wide bed WTT 1970 chevy front end for 67/68 chevy front end WTT 2 15x10 american racing outlaw 2 wheels for 2 of the same in a 15x7 or 15x8
|
|
|
|
08-22-2007, 03:20 PM
|
#2 |
|
Registered User
Join Date: Jan 2007
Location: OKlahoma
Posts: 6
|
Re: need drive shaft help!!
I run a one piece from a 68 gremlin in mine
|
|
|
|
|
08-22-2007, 03:37 PM
|
#3 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: need drive shaft help!!
get tape measure crawl under truck measure thats the way you'll get a correct measurement
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
08-22-2007, 04:09 PM
|
#4 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
Re: need drive shaft help!!
4 ft 11 inches was what mine used.. you failed to mention if it was a long shaft or short shaft.
|
|
|
|
|
08-22-2007, 06:29 PM
|
#5 |
|
Senior Member
Join Date: Apr 2007
Location: East Texas
Posts: 549
|
Re: need drive shaft help!!
i dont know if its a long or short, i think i have the wrong one, because the u- joints mate up to the rearend as they should
__________________
Justin 1970 c/10 short wide bed WTT 1970 chevy front end for 67/68 chevy front end WTT 2 15x10 american racing outlaw 2 wheels for 2 of the same in a 15x7 or 15x8
|
|
|
|
|
08-22-2007, 06:36 PM
|
#6 |
|
Registered User
Join Date: Jun 2007
Location: DFW (Forney)
Posts: 1,529
|
Re: need drive shaft help!!
better call or go to the local driveshaft shop and ask them what they measure from or you might have to do it twice. i speak from experience .2 driveshafts cost me 400$.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
