Parking Brake Lever Removal

[1970pelle]

I don't have a scanner.I have a 85 service manual.It says(1)Place parking brake pedal or handle in the released position.(2)Remove nuts from the engine compartment on C,K and G models or bolts from the mounting brackets on P models.Take notice of the spacers on P models for reinstallation.(3) Disconnect the release Handle rod at the parking brake assembly end(C-K models).(4) Remove the bolts from the underside of the dash and lower the brake assembly(C-K-G Models).(5) C-K-G Models-Disconnect the cable ball from the parking clevis and remove the assembly.Installation. (1) Reverse the removal procedure.Torgure all bolts and nuts.After installing the clevis pin.Adjust the cable if necessary as outlined below.Torgure specs. To dash 100 in. Ibs.,To Ip,Kick panel,floorpan 100 in. Ibs.Cable Clips-Screws,Bolts 150 in. Ibs.