|
01-04-2008, 06:40 PM
|
#1 |
|
Registered User
Join Date: Oct 2007
Location: Grapevine, TX
Posts: 58
|
steering column
I am putting in a tilt steering column from a mid 80s blazer and was wondering what I can do to cover the key hole and shift opening on the column. I plan on using the stock key (in dash) and mounting the automatic shifter on the floor.
Thanks Mark |
|
|
|
01-04-2008, 06:45 PM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
Re: steering column
You'd be way ahead to sell that column, and get one out of a 72 - 81 chevy/GMC van. They are very close to being a direct swap, and very few could ever tell it was not a stock piece.
the one you have has the issues you mentioned, and also it is larget in diameter too if i remember right. |
|
|
|
|
01-05-2008, 02:48 AM
|
#3 |
|
Senior Member
Join Date: Apr 2005
Location: Joppa, Maryland
Posts: 4,408
|
Re: steering column
__________________
1997 GMC Sierra Ext 1965 Mustang |
|
|
|
|
01-05-2008, 04:35 PM
|
#4 |
|
TILT COLUMN GURU
 
Join Date: Dec 2006
Location: FRESNO CA
Posts: 4,276
|
Re: steering column
Check out this link for the correct tilt column you need.
http://67-72chevytrucks.com/vboard/s...teering+column |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
