84 with a Dropmember

[PBFAB.COM]

Originally Posted by SCOTI

Nate,
I can't believe I missed this thread. Is that the same truck we pushed in/out of the shop when Keith & I were out there?

What's the rear suspension going to be?

That's the truck... but it didn't feel like you "helped" push it!
At least you didn't try to sever the fingers off my left hand!

The rear features a bolt-on notch that'll lay the frame on a 30" tire, bolt-on parallel four-link with panhard, sleeved bags, and some pretty blue Monroe shocks. I will get some more pics up of the rear over the next couple/few weeks. I have to take it apart and finish weld a couple spots, have it powdercoated, and then reinstall everything.

I will also include some engine compartment pics... good news for you guys wanting to keep the factory A/C and heater box... it fits with a 27" tall tire. You can slide a piece of paper between the tire and the blower motor when it's fully deflated. I would recommend a new blower motor that is a bit shorter than the factory one, or one can always section the box a little... not much.