Auto tranny linkage help, PLEASE!!!

[Dads 68 GMC]

I switched from a manual to an auto trans. I took the pivot bracket off a 1968 c-10. I think the bracket off of this 2x4 might be different from a 4x4. my frame does not have the holes I need, do I need to drill 2 holes and get a different bracket? if so does someone have the bracket I need? I can do paypal or whatever you need, Thanx,Philip

[ckhd]

You should think about the linkage kit from bowtie overdrives.

http://www.bowtieoverdrives.com/cata...php?ITEMID=193

[krue]

I'll try to remember to go look on my 4x Blazer and see what bracket it uses in the morning.

[FLEET72]

Originally Posted by ckhd

You should think about the linkage kit from bowtie overdrives.

http://www.bowtieoverdrives.com/cata...php?ITEMID=193

I have that linkage on my 72, bought it direct from Kugel. The 1 drawback is that it does not isolate motor torque from being transmitted to the shifter itself.

[krue]

Your engine must have a lot more torque than mine, 'cuz I have the above (put a 200-4r in it) and have no issues with it.

[FLEET72]

No, not a lot but it is noticeable. You can see the shifter move when under heavy load.

[hilljob26]

the 4x4 bracket is different,its alot smaller then the 2wd.although that setup thats in the pioc above looks to be the way to go

[mrein3]

Originally Posted by Dads 68 GMC

I switched from a manual to an auto trans. I took the pivot bracket off a 1968 c-10. I think the bracket off of this 2x4 might be different from a 4x4. my frame does not have the holes I need, do I need to drill 2 holes and get a different bracket? if so does someone have the bracket I need? I can do paypal or whatever you need, Thanx,Philip

I don't know if this helps but I switched from a manual (3-speed column) to a th350 in my K10 4x4. I bought the tranny, adapter, and t-case out of a 1972 Blazer. While I was showing the guy how to get the tranny off the engine I talked him out of the shift linkage and bracket on the frame. On my truck frame I had to drill two holes for the bracket on the frame. It has worked fine since I installed it in December of 2001.

[Dads 68 GMC]

thanks for all the help guys, anyone have one of those little brackets that bolt on the frame? I would like to go that way.

[sneakysnake]

Here are all the pieces on a 2x4

[myoldchevytruck]

Hey Dads 68 GMC,

Check with either board members teeitup or billsbowtie. Seems one of them had a large assortment of parts in a recent thread and I remember seeing that frame bracket.

[krue]

Your best bet will be to post a WTB thread on the parts board, please don't buy/sell anywhere else.

BTW here's a pic of what's on my Blazer so you'll know what to look for.