|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-14-2008, 03:08 AM
|
#1 |
|
1970 Daily Driver
Join Date: Jun 2007
Location: Glenns Ferry IDAHO
Posts: 1,038
|
Vinatage Air Core support hole size?
I am going to borrow some hole saws from a friend because I can not find mine. in the vintage air directions it calls out a 2-1/2" hole for the dash. My question is what size is the one that goes through the core support? I don't see it called out. This one.
__________________
It's not truly yours if you didn't build it yourself or if you don't do your own maintenance. |
|
|
|
04-14-2008, 04:19 PM
|
#2 |
|
Registered User
 
Join Date: Jan 2008
Location: St.Petersburg,Fl
Posts: 1,267
|
Re: Vinatage Air Core support hole size?
I have Vintage air,Ill get you the size tomorrow.
|
|
|
|
|
04-14-2008, 07:12 PM
|
#3 |
|
1970 Daily Driver
Join Date: Jun 2007
Location: Glenns Ferry IDAHO
Posts: 1,038
|
Re: Vinatage Air Core support hole size?
Thanks Greg. I was just going to buy some new ones, but I priced them out at Home Depot and it was $90 for the kit. If I can get the sizes from you then I can just borrow a couple from my friend. That's $90 that will pay for my 3-groove crank shaft pulley that I am missing!
 Thanks again and I will be sure to leave you positive reputation points for helping me out!
__________________
It's not truly yours if you didn't build it yourself or if you don't do your own maintenance. |
|
|
|
|
04-16-2008, 12:47 AM
|
#4 |
|
Registered User
Join Date: Jan 2008
Location: St.Petersburg,Fl
Posts: 1,267
|
Re: Vinatage Air Core support hole size?
The hole size your looking for is 1-1/4 inch.I used an electrical knock out punch by Greenlee, and it worked perfect without hurting the paint.Good luck
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
