where to get 4 speed coumumn bearings at - The 1947 - Present Chevrolet & GMC Truck Message Board Network

bdydrp97s10 · 04-23-2008, 05:13 AM

im thinking about gettingi a 4 speed coulumn, but there is some slop in it.. where can i get the bearings to fix this

JimKshortstep4x4 · 04-23-2008, 11:50 AM

If you are working with a stock non-tilt column then the bearings are the same as the other columns. I believe the bearings are still available from the dealer.

Is the lower spring in place? Without the spring or if it is not adjusted correctly there will be looseness in the bearings.

Jim

04-23-2008, 05:13 AM	#1
bdydrp97s10 Registered User Join Date: Dec 2007 Location: Johnson City TN Posts: 570	where to get 4 speed coumumn bearings at im thinking about gettingi a 4 speed coulumn, but there is some slop in it.. where can i get the bearings to fix this

04-23-2008, 11:50 AM	#2
JimKshortstep4x4 Senior Member Join Date: Jul 2001 Location: Muskegon,MI,USA Posts: 6,026	Re: where to get 4 speed coumumn bearings at If you are working with a stock non-tilt column then the bearings are the same as the other columns. I believe the bearings are still available from the dealer. Is the lower spring in place? Without the spring or if it is not adjusted correctly there will be looseness in the bearings. Jim __________________ 1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC Last edited by JimKshortstep4x4; 04-23-2008 at 11:51 AM. Reason: Added wording

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.