Truck is getting hot....

[64c20crewcab]

Originally Posted by justcuz

Norm you should be able to get it at any good auto supply. It may be the same as a Chevelle or passenger car of the same year. It has a connector on the top for a slip on spade connnector IIRC. Kind of looks like a little mushroom head.

Cuz,
The s.u. I replaced last year was for the year of the motor - '85 and earlier. Looks as you describe but will go out and get another for a 64-66 truck - if possible.

Originally Posted by Bob66

Keep an eye on your flex fan my friend, those things crack around the rivets after a while, I had one let go once and it swung out like a switch blade and sheared off my upper radiator water neck, chopped my bottom hose and tranny cooler lines. But that was a Ford, so it couldn't ever happen in a Chevy, right? Just a thought, does your radiator have a transmission cooler built into it? do you have an auxiliary tranny cooler?

Bob, Will be swappin out the flex fan today for the fan & clutch. Will take a look at the flex fan too.

Did some reading up on 19" fan install yesterday. According to the info fan should be 2/3 inside the shroud and 1/3 outside. This answers my earlier question. Yes the new rad has a built in tranny cooler and no aux cooler.

Swapping out the rad support as well. Passenger side frame mount rotted out sometime before I bought the truck in 05! Recently found a decent replacement locally. I cleaned, prepped, and coated with POR-15 black and fogged with Rustolium flatback yesterday/lastnight. This will give it a duller finish and not the high gloss finish. Hides some of the brush strokes as well. Will have the other rad support repaired, blasted and powdercoated in the next few weeks.

THANKS GUYS!!