|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-28-2001, 08:41 PM
|
#1 |
|
Senior Member
 
Join Date: Dec 1999
Location: Darrington, Washington
Posts: 3,963
|
What year was Power Windows and Locks offered?
Looking to install in a 73.
|
|
|
|
02-28-2001, 11:41 PM
|
#2 |
|
Vortec 350's Suck
Join Date: Nov 2000
Location: Pickardville Alberta Canada
Posts: 544
|
The first years for power windows and locks was 1977. With that in mind you should be able to pull the whole setup from a 77 up truck including wiring and all the internals of the doors and install them on your 73. Of course the complete door off a 77 truck would be a good swap also for the setup without as much disassembly and reassembly.
------------------ 69 CST, 402 steel crank, heavy rods polished ported heads 2.19/1.88 should be 450+ 700R4 373 Posi buckets/console tilt tach 4wheel discs Daily Driver: 92 Chev 4x4 350 auto
__________________
69 Chev CST 10 reg cab lwb Daily Driver: 92 Chev Reg Cab LWB Silverado 4x4, K.I.A 7:51 AM 04/22/03 Will be resurrected |
|
|
|
|
03-01-2001, 07:26 PM
|
#3 |
|
Registered User
Join Date: Mar 2001
Location: Birmingham, AL
Posts: 3
|
Tried to post this last night, but my account is all screwed up right now. So I registered again.......
It was 77, 77-91 doors are the same. You will need to change the complete door. 73-76 doors can't be used for the power motors. Here is a pic of the comparison. I can tell you what the problems will be if you can tell from the photos. 73-76 door  77-91 door  There are also 2 versions of the power motors. The early style 77-80 are a little stronger/bigger motor than the latter. ------------------ Chris Lucas www.captkaoscustoms.com |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
