![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
![]() Join Date: Apr 2005
Location: Medford, MA
Posts: 307
|
Upper Control Arm Mounting Thread Size
Does anyone know the thread size on the studs that hold the upper control arm to the frame? I needed an impact wrench to get the nuts off because the threads were so rusty. I want to clean up the threads on the studs and nuts so that I can get a good clean reading on the torque wrench when I re-install everything.
Last edited by Turbo85GMC; 09-08-2008 at 08:05 AM. |
![]() |
![]() |
![]() |
#2 |
Happy to be here
![]() Join Date: Mar 2000
Location: Cypress, TX
Posts: 39,023
|
Re: Upper Control Arm Mounting Thread Size
Anyone out there have an answer?
__________________
Follow me on Facebook and Instagram @N2trux.com Articles- "Jake" the 84 to 74 crewcab "Elwood" the77_Remix 85 GMC Sierra "Scarlett" "Refining Sierra" |
![]() |
![]() |
![]() |
#3 |
BAD BOW-Silverado XST
Join Date: May 2000
Location: Senior Member from Austin, TX
Posts: 6,431
|
Re: Upper Control Arm Mounting Thread Size
I would not clean them off too much. I brushed mine and reinstalled them. Tight them snuggly. When you get a front end alignment, they'll torque them for you.
Check here http://www.torkspec.com/torkspec.aspx Last edited by gchemist; 09-09-2008 at 10:34 PM. |
![]() |
![]() |
![]() |
#4 |
It'd be alot cooler if you did
Join Date: May 2003
Location: Three Rivers, MI
Posts: 2,345
|
Re: Upper Control Arm Mounting Thread Size
i believe they are 1/2-20 I will check Wednesday.
|
![]() |
![]() |
![]() |
#5 |
Registered User
![]() Join Date: Apr 2005
Location: Medford, MA
Posts: 307
|
Re: Upper Control Arm Mounting Thread Size
Thanks for the feedback!
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|