Motor mount / tower ?'s

[my67chevytruck]

Hello,

We have a father / son 67 swb c-10 build that we are getting ready to do a crossmember swap to a '72 for disk brakes. Will the 67 sbc motor stands/mounts bolt to a 72 crossmember? I am thinking they will but want to be certain. The parts truck had BBC motor stands originally. Thanks for any help you can provide, i want to make sure i have all the needed parts before i start the swap.

[Classic Bowties]

Yes, they used the same sbc tower from 67 to 72.

[my67chevytruck]

Thanks for the quick reply. Do the mounts separate from the tower, as i didnt see a bolt going through the rubber mount, but it was late when i looked. I may have more questions in the near future.

Thanks as always...

[Classic Bowties]

Yes, the mounts are bolted to the block with three bolt and should unbolt from the towers by removing the single center bolt/washer on bottom side of stand, if they are 67-72 sbc towers.

[my67chevytruck]

ok, thanks for the reply.I saw where it was bolted to the block with 3 bolts. I will go see if i can see the single bolt. so to pull the motor will i have access to unbolt the single bolt, or will i have to unbolt from the block? Excuse my ignorance, but I am trying to make sure i pull the motor/trans the most efficient way.

As always we appreciate your help.

[Classic Bowties]

Originally Posted by my67chevytruck

I will go see if i can see the single bolt. so to pull the motor will i have access to unbolt the single bolt, or will i have to unbolt from the block?

Just remove the single bolt running up thru the tower and into the mount/bushing, one on each side and you are ready to lift out.

[my67chevytruck]

Thanks again Classic. We appreciate your help.

[Longhorn Man]

a couple photos to give you an idea.
This was on small block frame mounts, but they mount on there the same way

[my67chevytruck]

Thank you longhorn. the pics help alot. Thanks to all, this board rocks.