|
02-18-2003, 10:09 AM
|
#1 |
|
Registered User
Join Date: Sep 2000
Location: huntington,texas,united states
Posts: 399
|
welding on rearend?
is it ok to weld on the rear axle with everything intact? i did some work to my trailing arms straitening them out and now my pinion angle is off. i want to cut my axle saddles off and reweld them in a better position. is this ok? thanks
__________________
1972 chevy long bed. Currently under construction!! Bagged, 383/700r4. |
|
|
|
02-18-2003, 10:24 AM
|
#2 |
|
Mike
Join Date: Jan 2003
Location: west chester pa
Posts: 2,474
|
I would be careful as to how much heat you apply.Skip your welds from side to side so it dn't warp the tubes.I've welded spring perches without any problems
__________________
70'c/10, 71 suburban4x4 402bb, 72suburban 4/6 drop, 72k/5 4x4 blazer 4" lift 35 tires |
|
|
|
|
02-18-2003, 10:30 AM
|
#3 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
2 nd that, take you time & keep the heat down. if you can run a mig on it it will be less heat than the old stick welder also. Another thought, you should be able to get wedge shims to change the angle ....good luck,crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
