![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Nov 2001
Location: Moneta, VA USA
Posts: 3,094
|
Re: 66 gmc c10 transmission swap to sm465
I would go with an original Cast Iron Bell. One with the larger 4-Speed hole in it. I'm not too familiar with the newer parts but does your Aluminum Bell have a bottom pan for easy access?
Bill Last edited by C10 - C90 Bill; 11-19-2008 at 10:42 PM. |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Nov 2008
Location: Sebastopol, CA
Posts: 24
|
Re: 66 gmc c10 transmission swap to sm465
No, the aluminum one goes all the way around the flywheel and doesn't have the motor mount provisions.
I will see if I can find a cast iron version from a 68-72. If I can, hopefully my stock throwout arm will work with the sm465 throwout bearing. I think it will since those bellhousings came with sm465's. I guess I should still make another crossmember the support the rear of the tranny. I will have three sets of mounting points for the drivetrain! Any tips on where to find a high hump for a 66? Are they very common in wrecking yards? Thanks, Dan |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|