![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
![]() Join Date: Nov 2004
Location: Southern Nevada
Posts: 532
|
Need to detail my brake booster..any tips?
I'm going through my engine compartment and want to do the booster, master cylinder, Proportioning Valve etc? Other than just bleeding them can I expect any hassles if I take it apart to paint and clean?
![]()
__________________
1972 K-10 SWB Cheyenne |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Feb 2004
Location: Albany, NY
Posts: 522
|
Re: Need to detail my brake booster..any tips?
other than bleeding, i cant think of anything that's going to give you any trouble...
some of the contours of the master cylinder are a bit hard to get a wire wheel in. just make sure you have a couple sizes and shapes if you are going to wheel it. If you paint it, remember that Brakleen will soften a lot of paints (ie... lacquers, and most spray cans i have used) but it's still a good pre-paint solvent. Enjoy the results!! ![]() -ian
__________________
RN U OVR Last edited by Senator350; 11-24-2008 at 10:00 AM. |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|