Qjet won't kick down - The 1947 - Present Chevrolet & GMC Truck Message Board Network

57larry · 12-12-2008, 07:23 PM

when it was warm, my 84 C10 with a 350 and Q jet carb ran fine. Now it's cold and it idles high and I can't get it to kick down. it has power going to the electric choke. what should I check? thanks

Restrorob · 12-12-2008, 09:28 PM

Larry,

I would test the choke with a multimeter to make sure it has a closed circuit, It could be blown. Also check your high idle cam and linkage on the carb for any binding/stiffness.

Good Luck

57larry · 12-12-2008, 09:57 PM

ok, thanks, I'll check the ground

Restrorob · 12-12-2008, 11:15 PM

It's not really a 'ground' your checking, Un-plug the wire and set your meter on ohm's scale. Touch one test lead to the wire connector and the other to any part of the carb, You should get a closed circuit reading if not the heater windings are blown.....

57larry · 12-13-2008, 11:43 AM

are the choke windings able to be replaced?

Restrorob · 12-13-2008, 04:41 PM

No, Just replace the choke assembly then adjust while the engine is cold.

84 400 · 12-13-2008, 05:40 PM

I also have a Q- jet question. On my 77 with a 350 if i tap the pedal it kicks down but when I place it back into park after driving it idles high again. Any ideas what could be causing this.

thanks

73chevyman · 12-13-2008, 06:44 PM

its a QJET thats why i got a eldy

84 400 · 12-13-2008, 08:43 PM

Quote:

Originally Posted by 73chevyman

its a QJET thats why i got a eldy

I have an eddy on my 84 and love it. easy to tune and runs dead on all the time. But I am not switching to an eddy on my 77. If anything I will rebuild th e Q jet 25.00 for a rebuild kit and a half hours worth of work..

Anyone have ideas on mine kicking down but idling back up when placed in park?

Thanks

Restrorob · 12-13-2008, 10:20 PM

Quote:

Originally Posted by 84 400

Anyone have ideas on mine kicking down but idling back up when placed in park?

Could be a couple things, When it idles high in park after driving can you tap the gas and have it idle back down ?

**Corts60** · 12-14-2008, 05:26 PM

OK, More than likely your fast idle cam is sticking on the first cam step. One reason could be that your choke pull-off is not operating properly. That cost's about 15 bucks and is a pretty important component that most people overlook during a rebuild. What style choke do you have? Electric, divorced?

Quote:

Originally Posted by 84 400

I have an eddy on my 84 and love it. easy to tune and runs dead on all the time. But I am not switching to an eddy on my 77. If anything I will rebuild th e Q jet 25.00 for a rebuild kit and a half hours worth of work..

Anyone have ideas on mine kicking down but idling back up when placed in park?

Thanks

84 400 · 12-14-2008, 09:24 PM

yes when placed back into park it idles high but will kick down with a tap of the gas. I am not sure what style choke it is . I will have to take a closer look on friday and get back to you.

Albatrossian · 12-15-2008, 07:42 AM

Quote:

Originally Posted by 84 400

yes when placed back into park it idles high but will kick down with a tap of the gas. I am not sure what style choke it is . I will have to take a closer look on friday and get back to you.

More than likely it's the pull off.. I've seen that happen alot.. and a sticking linkage. WD40 it. QJets are awesome carbs.. I have a 780cfm version that I had professionally built. Crisp, clean response that's like a lightswitch. I get good mileage and equal or better performance than any Edelbrock or Holley.

12-12-2008, 07:23 PM	#1
57larry Registered User Join Date: Nov 2007 Location: Indianapolis Posts: 1,161	Qjet won't kick down when it was warm, my 84 C10 with a 350 and Q jet carb ran fine. Now it's cold and it idles high and I can't get it to kick down. it has power going to the electric choke. what should I check? thanks

12-12-2008, 09:28 PM	#2
Restrorob The One And Only !!! Join Date: Jan 2007 Location: Hole in the woods Florida Posts: 4,567	Re: Qjet won't kick down Larry, I would test the choke with a multimeter to make sure it has a closed circuit, It could be blown. Also check your high idle cam and linkage on the carb for any binding/stiffness. Good Luck __________________ 93 Jeep XJ 88 Buick La Sabra Toys; 88 TA-GTA in the works.... 97 GMC Ext. Cab 502 Crate 5 Spd......Sucks Gas But Haulz Azz ! The primary function of an Engineer is to make it difficult for the Fabricator and impossible for the Mechanic. *"Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!*

12-12-2008, 09:57 PM	#3
57larry Registered User Join Date: Nov 2007 Location: Indianapolis Posts: 1,161	Re: Qjet won't kick down ok, thanks, I'll check the ground

12-12-2008, 11:15 PM	#4
Restrorob The One And Only !!! Join Date: Jan 2007 Location: Hole in the woods Florida Posts: 4,567	Re: Qjet won't kick down It's not really a 'ground' your checking, Un-plug the wire and set your meter on ohm's scale. Touch one test lead to the wire connector and the other to any part of the carb, You should get a closed circuit reading if not the heater windings are blown..... __________________ 93 Jeep XJ 88 Buick La Sabra Toys; 88 TA-GTA in the works.... 97 GMC Ext. Cab 502 Crate 5 Spd......Sucks Gas But Haulz Azz ! The primary function of an Engineer is to make it difficult for the Fabricator and impossible for the Mechanic. *"Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!*

12-13-2008, 11:43 AM	#5
57larry Registered User Join Date: Nov 2007 Location: Indianapolis Posts: 1,161	Re: Qjet won't kick down are the choke windings able to be replaced?

12-13-2008, 04:41 PM	#6
Restrorob The One And Only !!! Join Date: Jan 2007 Location: Hole in the woods Florida Posts: 4,567	Re: Qjet won't kick down No, Just replace the choke assembly then adjust while the engine is cold. __________________ 93 Jeep XJ 88 Buick La Sabra Toys; 88 TA-GTA in the works.... 97 GMC Ext. Cab 502 Crate 5 Spd......Sucks Gas But Haulz Azz ! The primary function of an Engineer is to make it difficult for the Fabricator and impossible for the Mechanic. *"Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!*

12-13-2008, 05:40 PM	#7
84 400 Sb 400 club Join Date: Nov 2005 Location: NH / MA Posts: 2,746	Re: Qjet won't kick down I also have a Q- jet question. On my 77 with a 350 if i tap the pedal it kicks down but when I place it back into park after driving it idles high again. Any ideas what could be causing this. thanks __________________ 1984 chevy c10, built 400sb,.(SOLD) 77 K10 Project / daily driver "The Grinch" http://67-72chevytrucks.com/vboard/s...d.php?t=318363 1956 Willys Wagon (327 chevy) Project (Now Buick 225) 1980 Corvette L-48 4 speed 1992 Mustang GT built 5.0 5 speed 1985 C10 LWB Sold 1982 K10 SWB plow truck Parted out 1986 D30 M1028 fire brush truck Parted out

12-13-2008, 06:44 PM	#8
73chevyman Registered User Join Date: Nov 2008 Location: Lusby, MD Posts: 563	Re: Qjet won't kick down its a QJET thats why i got a eldy __________________ http://67-72chevytrucks.com/vboard/group.php?groupid=37 73 C10 Fleetside If it ain't a Chevy it's foreign http://hotridesmag.com/

12-14-2008, 09:24 PM	#12
84 400 Sb 400 club Join Date: Nov 2005 Location: NH / MA Posts: 2,746	Re: Qjet won't kick down yes when placed back into park it idles high but will kick down with a tap of the gas. I am not sure what style choke it is . I will have to take a closer look on friday and get back to you. __________________ 1984 chevy c10, built 400sb,.(SOLD) 77 K10 Project / daily driver "The Grinch" http://67-72chevytrucks.com/vboard/s...d.php?t=318363 1956 Willys Wagon (327 chevy) Project (Now Buick 225) 1980 Corvette L-48 4 speed 1992 Mustang GT built 5.0 5 speed 1985 C10 LWB Sold 1982 K10 SWB plow truck Parted out 1986 D30 M1028 fire brush truck Parted out

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.