|
03-16-2009, 08:19 PM
|
#1 |
|
Registered User
Join Date: Mar 2006
Location: Norman, Oklahoma
Posts: 553
|
Motor Swap Questions
Guys I have a few questions, I tried searching but havent had much luck altough it may be scattered throughout the board.. I planned on swapping a nicely built small block into my 85 shortwide but i think i want to change plans... What would i need to put a 87-95 motor (pre vortec) in my truck and keep it carbd? would i need any special wiring or sensors? They make carbd intakes for these motors correct?
__________________
1973 Chevrolet C20 (Under Construction) |
|
|
|
03-16-2009, 08:26 PM
|
#2 |
|
Registered User
Join Date: Jan 2007
Location: Lexington, TN
Posts: 1,427
|
Re: Motor Swap Questions
All you need is a 87-95 Tbi to carb intake. (I have one by the way) Plus maybe exaust manifolds.
__________________
The fleet 94 Chevy 4x4 reg cab 2018 Traverse (wifes car) 1977 SWB stepside 1949 Chevy truck Last edited by cjracing15; 03-16-2009 at 08:28 PM. |
|
|
|
|
03-17-2009, 09:42 AM
|
#3 |
|
Registered User
Join Date: Jan 2009
Location: northern mn
Posts: 5
|
Re: Motor Swap Questions
why using a 87+ engine? roller cam in your future or what.
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
