|
03-21-2009, 03:09 PM
|
#1 |
|
Registered User
 
Join Date: Dec 2008
Location: Mt. Pleasant, TX
Posts: 268
|
Rear disc swap
i put rear disc on my 68. i bought the a kit. it fits good except the rotors drag the pad, like the pads are too thick. i dont have the brakes on my frame fully done yet. just wondering if this is normal? will they open up when i put the master cylinder on and put fluid in them?
|
|
|
|
03-21-2009, 05:20 PM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Re: Rear disc swap
are you able to turn the wheel by hand? Discs are designed to drag a bit.
|
|
|
|
|
03-21-2009, 06:05 PM
|
#3 |
|
Registered User
Join Date: Dec 2008
Location: Mt. Pleasant, TX
Posts: 268
|
Re: Rear disc swap
i think so i put them awhile ago just now got around to posting. i know it rolls
|
|
|
|
|
03-21-2009, 06:41 PM
|
#4 |
|
Senior Member
Join Date: Aug 2004
Location: Centennial, CO
Posts: 2,935
|
Re: Rear disc swap
If you can turn it by hand, you're probably ok. Like Andy says, they're designed to drag a bit, especially when the brakes aren't bedded in yet.
__________________
ClusterTruck: 68 C10 Bought in 89, wrecked in 03. Slow low $ rebuild started '17. 6.0 & TKO http://67-72chevytrucks.com/vboard/s...d.php?t=788602 93 K1500 Short Step, 350, NV4500, EBL flash ECU. Vortec heads & roller cam someday... 05 Jeep Wrangler Unlimited. 3” lift & 6-speed 02 E320 the insurance total “free car” 13 Tahoe LTZ |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
