|
04-11-2009, 10:29 AM
|
#1 |
|
Registered User
Join Date: Nov 2008
Location: Ponder, Texas
Posts: 94
|
Support
Finally got all the parts and machine work done to assemble my
motor. Then the Hot Rod Gremlins show up. Cam bearings won't fit [Little "M"]. Call Jeg's. They send 1 bearing. Call Jeg's. They say "sorry" it's shown as a set. They send remaining bearings overnight and eat the freight. Good service. Cam bearings won't fit. Call Dart [brilliant]. They tell me my bearings are oversize and give me the correct part #. Call Reher-Morrison, they're just across town, they have them $60.00. Finally resume assembly. Gasket kit has 2 front seals and no rear. Off to Autozone. Discover crack in SuperDamper. Call ATI. Order new hub $124.00. Better now than later. Continue assembly. Ever thing is smooth UNTIL a pushrod slips and slides down into the valley under the intake. OK guy's tell me again. Why do we do this. |
|
|
|
04-11-2009, 10:42 AM
|
#2 |
|
Registered User
Join Date: Nov 2008
Location: Ponder, Texas
Posts: 94
|
Re: Support
Maybe this is why.
|
|
|
|
|
04-11-2009, 11:54 AM
|
#3 | |
|
Registered User
 
Join Date: Jul 2007
Location: Pittsburgh, PA
Posts: 294
|
Re: Support
Quote:
__________________
John aka "Milner" PA-IndianRider - Pittsburgh, PA 70 Chevy C10 Stepside "Gasser/Altered Drag Race Hot Rod" Where were You in '62 ? Last edited by PA-IndianRider; 04-11-2009 at 11:56 AM. |
|
|
|
|
|
04-11-2009, 11:55 AM
|
#4 | |
|
Registered User
Join Date: Jul 2007
Location: Pittsburgh, PA
Posts: 294
|
Re: Support
Quote:
__________________
John aka "Milner" PA-IndianRider - Pittsburgh, PA 70 Chevy C10 Stepside "Gasser/Altered Drag Race Hot Rod" Where were You in '62 ? Last edited by PA-IndianRider; 04-11-2009 at 11:56 AM. |
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
