|
03-23-2003, 08:00 PM
|
#1 |
|
PROJECT 7DEUCE
 
Join Date: Dec 2002
Location: GRANTS PASS OR
Posts: 21,608
|
shift knob
I got my short shifter for my blazer but can not seem to get the old black knob off the old shifter anyone have this problem before....
__________________
GO BIG GREEN  GO DUCKSMEMBER #6377 72 k-5 daily driver 6'' lift 35'' 350-350-205 slowly getting rust free. Project "7DEUCE" check out my build http://67-72chevytrucks.com/vboard/s...d.php?t=267665 Tim Powell..R.I.P EastSideLowlife..... R.I.P.. |
|
|
|
03-23-2003, 08:01 PM
|
#2 |
|
Dreaminator
Join Date: Feb 2003
Location: Broken Arrow, Oklahoma
Posts: 156
|
Geez mine keeps falling off!
__________________
The Dreaminator Daily Driver 1971 Cheyenne 10 Lwb Tilt/Tac 402 .030 TH400. |
|
|
|
|
03-23-2003, 08:40 PM
|
#3 |
|
Registered User
Join Date: Dec 2001
Location: Spring Creek, nevada. U.S.A.
Posts: 456
|
heat it with a little propane torch down on one of the bends away from the knob about two inchs down.heat slow because if you get it to hot the knob melts.heat for a little bit then stop and wait a few seconds, while pulling on the knob. the heat will transfer up the shift arm while your waiting and start to heat the knob allowing it to loosen and pull off. good luck hope this helps
__________________
69 chevy short wide box project 70 GMC jimmy project |
|
|
|
|
03-23-2003, 10:37 PM
|
#4 |
|
Registered User
Join Date: Dec 1999
Location: BRADENTON FLA
Posts: 3,269
|
Put it in a pan of boiling water.
__________________
Rest in Peace Ed. Thanks for all the good times. |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
