blinker in dash stays on - The 1947 - Present Chevrolet & GMC Truck Message Board Network

71Custom10 · 03-19-2003, 01:57 AM

Whenever I turn my lights on the left blinker indicator in the dash comes on but it shines real dim. When you turn the blinker on it goes out and the blinker functions normally. Turn it off and the light is on again. Where do I start?
Andrew

HotRod929 · 03-19-2003, 02:03 AM

Same thing is happening to me except with my right blinker. I think it might have something to do with a bad ground but i dont know cus I havnt had time to look at it. Let me knoe if you find anything out please.

HotRod

mtdave2 · 03-19-2003, 02:52 AM

yep somehthing is grounding.. prob in the buld connector.. take the bulb out and look at it..lol

skyhawk1 · 03-19-2003, 06:57 AM

IMO you need a better ground on the front park lights. I had the same problem. I used a short piece of wire and a couple of stake-ons and ran a ground wire from one of the bolts that holds the park light in place over to the radiator support. Havn't had any problems since.

Lippyp · 03-19-2003, 07:11 AM

Check your floor mounted dimmer switch. They tend t get wet a corrode and cause all sorts of dash related electrical problems. Clean up the mounting area on the floor for it and replace it if it is looking ropey.

Blue Beard · 03-19-2003, 09:09 AM

You've got a ground problem for sure......mine was doing the same thing, left turn signal.

After a total run down of the entire system, under the dash and the hood. finally found the positive cable was almost burnt in half......

Good luck, tracing these are hard work.....

TROYLV · 03-19-2003, 10:00 AM

check your bulbs. one of the filaments in a bulb is making contact on the park ligh filamentin that bulb. had this happen before.

Long Knight · 03-19-2003, 12:12 PM

I'm sure I will have this problem soon. I noticed the other day that i can see all the wires going to the rear through the vent holes (thanks to the rust fairy) in my rockers. Only a matter of time before some big chunk of something falls off and trys to take the wiring with it.

krazy_texan · 03-19-2003, 11:10 PM

i have the same prob with this but on the right side, i have good grounds but am going to rewire the whole truck soon so i am going to deal with it for the time being and also when i turn on my brights i loose my dash lights, do you guys have that prob?

71Custom10 · 03-22-2003, 02:03 PM

I noticed the other night when I was following somebody that I could see my parking light in their bumper but the blinker wasn't working. I checked the bulb and it looked ok, but I replaced it anyway and the light doesn't satay on anymore.
Thanks,
Andrew

Longhorn Man · 03-23-2003, 01:53 AM

71Custom hit the nail on the head.
When this happens, the first thing to look at is your turn signal bulbs. This i the way GM used to set them up to inform you there is a bulb burned out.

TROYLV · 03-23-2003, 06:06 AM

i must be invisable on here. duh............. read my post. maybe i'll just let everyone figure out there own problems from here out. if anyone would like to know how this happens, ask and i'll explain it. by the way when you have a turn signal bulb burnt out it will not flash at all at the dash indicater. i can explain this also no gm didn't desiegn this ether, the flasher manufacturer did and it is this way in almost all older cars and trucks.

A.P. · 03-23-2003, 09:09 AM

Check your grounds. I had this problem with my right blinker. There wasn't good ground on my front blinker on the bumper.

Longhorn Man · 03-23-2003, 01:53 PM

Troy, i was just adding to your responce. The filaments do not need to be touching in order to cause his. You can remove a bulb all together and it will cause the same fault.
I was unsure that anyone else did this too. Good to know info.

TROYLV · 03-23-2003, 05:51 PM

sorry longhorn, i was to quick to jump. just ain't been a good week. blood sugar is up- got the flu- and some dumb a$$ calls at 1:30 in the morning. wouldn't be so bad, but sincei didn't answer first time she does it 5 more times. finaly get out of bed, expecting maybe one of my family is hurt - i get "is john there"? no john here. might as well stay up now. 2:30- again "is john there"--no its still the wrong number. oh, sorry- yea so am i. i get up early, but thats to early. bad part of being in a 24 hr. town i guess. sorry guy

Longhorn Man · 03-24-2003, 12:00 AM

no problem man.

03-19-2003, 01:57 AM	#1
71Custom10 Registered User Join Date: Feb 2000 Location: Temple, Texas Posts: 325	blinker in dash stays on Whenever I turn my lights on the left blinker indicator in the dash comes on but it shines real dim. When you turn the blinker on it goes out and the blinker functions normally. Turn it off and the light is on again. Where do I start? Andrew __________________ '67 Chevy Longbed Fleetside - Daily Driver(For Now) '72 Cheyene Longbed Fleetside-Daily Driver Best Towing Service

03-19-2003, 02:03 AM	#2
HotRod929 Registered User Join Date: Mar 2002 Location: Bondurant, IA but in Worcester, MA for school Posts: 767	Same thing is happening to me except with my right blinker. I think it might have something to do with a bad ground but i dont know cus I havnt had time to look at it. Let me knoe if you find anything out please. HotRod __________________ 1970 Chevy C-20 350 V-8 Turbo 350 w/ shift kit Dana 60 w/ 4.10 gears AND Powr-Loc POSI New Additions: Summit Headers 135amp alternator Proform HEI Edelbrock 1406 600cfm carb Sunpro Tach Powr-Loc POSI Edelbrock Performer RPM Intake MSD 6A Ignition Box AIM: HotRod929 Visit My Site: http://1970chevy.netfirms.com/

03-19-2003, 02:52 AM	#3
mtdave2 newly minted old timer Join Date: Dec 1999 Location: Hudson WI Posts: 3,521	yep somehthing is grounding.. prob in the buld connector.. take the bulb out and look at it..lol __________________ ____________________________________________ 72 c20 longhorn 65k org miles and counting! 69 k10 Suburban

03-19-2003, 06:57 AM	#4
skyhawk1 Registered User Join Date: Dec 2000 Location: Oceana WV USA Posts: 184	IMO you need a better ground on the front park lights. I had the same problem. I used a short piece of wire and a couple of stake-ons and ran a ground wire from one of the bolts that holds the park light in place over to the radiator support. Havn't had any problems since. __________________ "The World's a Mess"! 71 C-10 72 Suburban 2WD Oceana, West Virginia

03-19-2003, 07:11 AM	#5
Lippyp English Chevy Owner Join Date: May 2002 Location: Shropshire, UK/ Lot, France Posts: 1,848	Check your floor mounted dimmer switch. They tend t get wet a corrode and cause all sorts of dash related electrical problems. Clean up the mounting area on the floor for it and replace it if it is looking ropey. __________________ Phil '67 C10 long fleet. 350/TH350, 4 bbl Carter, K&N, Dual exhaust, loads of stuff coming soon 2001 S10 Blazer Daily Driver, bone stock 4 door 4x4 with manual transmission

03-19-2003, 09:09 AM	#6
Blue Beard Registered User Join Date: Jan 2003 Location: Washington State Posts: 8,831	You've got a ground problem for sure......mine was doing the same thing, left turn signal. After a total run down of the entire system, under the dash and the hood. finally found the positive cable was almost burnt in half...... Good luck, tracing these are hard work..... __________________ 1970 Chev CST 2003 Harley Fatboy 1975 Chevrolet Step Van 1956 Chev Bel Air 1977 Blazer 2WD For Sale $3000.00 1978 Blazer 2WD For Sale $7000.00 1978 Silverado 2005 Monte Carlo

03-19-2003, 10:00 AM	#7
TROYLV Registered User Join Date: Oct 2002 Location: LAS VEGAS, NV. Posts: 157	blinker light check your bulbs. one of the filaments in a bulb is making contact on the park ligh filamentin that bulb. had this happen before. __________________ troy wilson

03-19-2003, 12:12 PM	#8
Long Knight Spank 'em if you got 'em! Join Date: Nov 2002 Location: Kansas City Posts: 628	I'm sure I will have this problem soon. I noticed the other day that i can see all the wires going to the rear through the vent holes (thanks to the rust fairy) in my rockers. Only a matter of time before some big chunk of something falls off and trys to take the wiring with it. __________________ Long Knight '71 C-20, 350ci, TH350, Edl. 1406 Carb w/elec.choke, Ignitor ignition, Viper Tires, Orange Dipstick

03-19-2003, 11:10 PM	#9
krazy_texan Registered User Join Date: Oct 2002 Location: West Des Moines, Ia Posts: 3,233	i have the same prob with this but on the right side, i have good grounds but am going to rewire the whole truck soon so i am going to deal with it for the time being and also when i turn on my brights i loose my dash lights, do you guys have that prob? __________________ Krazy Texan My Trucks are made with Wrenches not Chop Sticks 1967 GMC 3/4 ton "Johnny Cash" 1990 v1500 suburban 1967 Ford f100 Swb 4x4 "green bean" GOD BLESS JESUS, JOHN WAYNE, AND THE ALAMO

03-22-2003, 02:03 PM	#10
71Custom10 Registered User Join Date: Feb 2000 Location: Temple, Texas Posts: 325	I noticed the other night when I was following somebody that I could see my parking light in their bumper but the blinker wasn't working. I checked the bulb and it looked ok, but I replaced it anyway and the light doesn't satay on anymore. Thanks, Andrew __________________ '67 Chevy Longbed Fleetside - Daily Driver(For Now) '72 Cheyene Longbed Fleetside-Daily Driver Best Towing Service

03-23-2003, 01:53 AM	#11
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	71Custom hit the nail on the head. When this happens, the first thing to look at is your turn signal bulbs. This i the way GM used to set them up to inform you there is a bulb burned out.

03-23-2003, 06:06 AM	#12
TROYLV Registered User Join Date: Oct 2002 Location: LAS VEGAS, NV. Posts: 157	blinker i must be invisable on here. duh............. read my post. maybe i'll just let everyone figure out there own problems from here out. if anyone would like to know how this happens, ask and i'll explain it. by the way when you have a turn signal bulb burnt out it will not flash at all at the dash indicater. i can explain this also no gm didn't desiegn this ether, the flasher manufacturer did and it is this way in almost all older cars and trucks. __________________ troy wilson

03-23-2003, 09:09 AM	#13
A.P. Black 72 Chevy Join Date: May 2002 Location: Los Angeles, California Posts: 662	Check your grounds. I had this problem with my right blinker. There wasn't good ground on my front blinker on the bumper.

03-23-2003, 01:53 PM	#14
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	Troy, i was just adding to your responce. The filaments do not need to be touching in order to cause his. You can remove a bulb all together and it will cause the same fault. I was unsure that anyone else did this too. Good to know info.

03-23-2003, 05:51 PM	#15
TROYLV Registered User Join Date: Oct 2002 Location: LAS VEGAS, NV. Posts: 157	blinker sorry longhorn, i was to quick to jump. just ain't been a good week. blood sugar is up- got the flu- and some dumb a$$ calls at 1:30 in the morning. wouldn't be so bad, but sincei didn't answer first time she does it 5 more times. finaly get out of bed, expecting maybe one of my family is hurt - i get "is john there"? no john here. might as well stay up now. 2:30- again "is john there"--no its still the wrong number. oh, sorry- yea so am i. i get up early, but thats to early. bad part of being in a 24 hr. town i guess. sorry guy __________________ troy wilson



Register or Log In To remove these advertisements.

03-24-2003, 12:00 AM	#16
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	no problem man.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Register or Log In To remove these advertisements.