|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-19-2009, 02:52 PM
|
#1 |
|
Registered User
Join Date: Feb 2008
Location: la
Posts: 345
|
chevy 350 rear main seal
What do i need to torque the cap bolts to after replacing the seal?
Also, do I even have to slide the trans back the replace (this is a 2wd 83 suburban), I should be able to just pull the cap and slide the top half out and replace it right? |
|
|
|
06-19-2009, 02:56 PM
|
#2 |
|
profeshinaly unimployed
Join Date: Dec 2008
Location: hazlehurst, GA
Posts: 1,232
|
Re: chevy 350 rear main seal
yeah and i forgot what u had to torque it too...i did mine not too long ago and u should have to move anything just drop the oil pan the oil pump and the rear main seal
__________________
"having mud flaps is like asking for a smaller trophy" |
|
|
|
|
06-19-2009, 03:57 PM
|
#3 | |
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: chevy 350 rear main seal
The torque on the main cap bolts is 70#. You don't have to move/remove the transmission, but getting the oil pan out of a 2 wheel drive can be a bit of a challenge.
__________________
You can review the site's rules here. Quote:
Bad planning on your part does not necessarily constitute an instant emergency on my part.... The great thing about being a pessimist is that you are either pleasantly surprised or right. 
|
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
