core support mounts

[brak]

what are the differences between the 67-68 core support mounts and the 69-72?

are they different because of the perches which are mounted on the frame, or the core support itself?

the reason i ask, is i am putting a 68 clip on my 72 and i'm not sure which mounts to use. I ordered a set of 68 mounts but they look like they are too small for the perch mounted to the frame. like they will just fall through the hole.

[LockDoc]

Originally Posted by brak

what are the differences between the 67-68 core support mounts and the 69-72?

are they different because of the perches which are mounted on the frame, or the core support itself?

the reason i ask, is i am putting a 68 clip on my 72 and i'm not sure which mounts to use. I ordered a set of 68 mounts but they look like they are too small for the perch mounted to the frame. like they will just fall through the hole.

Hey Clyde, I haven't seen you on the board for a while. Good to see you back. You might have to weld some washers in the hole to reduce the size. Other than that they are the same. I think the 69-72 support just sets up higher off the frame because of the thicker bushings.

LockDoc