Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
07-12-2009, 05:43 PM | #10 | |
Strongman Garage
Join Date: Apr 2000
Location: Salinas, CA
Posts: 10,241
|
Re: 68 GMC 4x4 Suburban build up
Quote:
Cleaned up the front frame rails and spray painted them semi gloss black yesterday. Bolted up the diy4x front shackle hangers today. Drilled out the frame for the bolt holes for the bottom of the frame rail. Thought I was done with rivets!! I forgot the fb52 kit uses the front body mount holes for the back two bolts on the rear shackle hanger so I chiseled the drivers side out. My plaguing problem of my POS compressor of course stalls the project at every corner as it only likes to cycle on 1-2 times a day! I'll get the pass side out tomorrow than I have to hole saw the frame for the new location. Not looking forward to that. I assume its a bad idea to not weld up the old hole right? do you use every one of these three holes? Got to pull the rear springs off my parts blazer and start rebuilding the 3/4 dana 44 and get all the parts for crossover steering..... Is there any reason to run a HI steer crossover steering kit if I'm not going to wheel hard? Instead of a standard crossover steering?
__________________
Kalle 68 GMC Suburban 1500 4x4 SOLD 69 Pontiac Lemans 99 Silverado 4.8 5 speed ECSB [ Facebook Instagram Subscribe on YOUTUBE |
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|