|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
07-19-2009, 03:56 PM
|
#11 |
|
Senior Member
Join Date: Aug 2005
Location: tulsa OK
Posts: 3,070
|
Re: project INCREDIBLE HULK 6.2L with 6L80E
after i welded the flanges on i had a little gap (between the fender and flange)..... after looking at it, it started to bug me....and i thought it would look better if it was smooth (no gap)... so i welded in the gap and smoothed it over....also note, that i rounded the sharp edges where the flanges came together...and finally the end result.
    
Last edited by 68 short step; 07-19-2009 at 04:02 PM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode