Fuel Fillers

[mas09ts]

Ok guys I just installed my under bed tank now im tryin to figure out how to run my hose to my marine fuel filler. Anyone got any pics of the hoses and such from the tank to the filler. Any help appreciated.

[Sammy]

Side fill or dead center straight up?

[mas09ts]

Originally Posted by Sammy

Side fill or dead center straight up?

I'm gonna try to put it in the fender, my stepside bed has no marker light also. . . I'm just not sure how to do the hose without it bending too much and crimping it. I bought a 3ft hose also thats not too flexible. . .

[harrdawg54]

What I think Sammy meant was, is the filler on the tank off to the side or straight up. Depending on where this filler is makes a big difference on where, and how difficult, the final filler is.

[mas09ts]

It's a side fill tank, its the LMC rear relocation tank.

[Sammy]

Yes, thats what I was referring to. I checked no pics of my hose from the tank to the filler. But what I done was checked outside diameter and went to a boat shop for the correct diameter and length. But that wasn't too reasonable on price thru the boat dealer. I think you would do better going to a custom tail pipe shop to bend you all the bends you need for the best job. Just don't use a radiator type hose because of the fuel eatting up the hose over time. As far as filler doors anything can be used that you desire, S-10, P/U, custom rod door found on ebay etc. Thats what I used. It came with the fuel cap that has a trap spring loaded door so you don't have to remove the cap. Sorry so long only have the one pic. good luck. Any more questions just post..

[mas09ts]

Thanks Sammy, Anyone else got any pics???

[mas09ts]

Anyone ????