20x9 , 6 inch bkspc, strongarms&bags, Problems??

[67cheby]

67 chevy running 20x9 inch wheels in front with strong arms and air bags, cpp new narrowed(modular) spindles , anyone running a similar set up ?? am i going to have steering issues?? i have all of this just not mounted yet , got a little scared thinking about the backspacing and if it would cause any problems. thanks

[n2billet]

Originally Posted by 67cheby

67 chevy running 20x9 inch wheels in front with strong arms and air bags, cpp new narrowed(modular) spindles , anyone running a similar set up ?? am i going to have steering issues?? i have all of this just not mounted yet , got a little scared thinking about the backspacing and if it would cause any problems. thanks

I ran 5 3/4 on the front of my red 68 without any issues, I don't see why another 1/4 would hurt you.

[67cheby]

could you drive yours aired out ???

[n2billet]

Originally Posted by 67cheby

could you drive yours aired out ???

I could after I bumped the air just enough to get the tire off the inner fender. I drove this truck with as little air as possible so it would look low (before the dropmember). It rode surprising nice with very little air

[67cheby]

what other modifications necessary with the dropmember, as far as driveline/transmission .. to the bottom of the cab.. i have been trying to resist the dropmember but, i dont know how much longer i can hold on...not long unless i ban myself from this website!!!

[n2billet]

Originally Posted by 67cheby

what other modifications necessary with the dropmember, as far as driveline/transmission .. to the bottom of the cab.. i have been trying to resist the dropmember but, i dont know how much longer i can hold on...not long unless i ban myself from this website!!!

The main modification your going to have with the dropmember is going to be inner fenders and hood hinges. I know that Nathan is currently working on the hood hinges so this may be covered in the next month or two. So, with that said what's holding you back on buying one of those new tubular dropmembers?

[67cheby]

i am already working on the inner fenders so i guess i will wait and see what he comes up with on the hood hinges !!! i just trying to figure out if its worth 1200 just for what ever i will get ?? i know it narrows the track but how much lower can i go , i know this sounds stupid but i want to keep the factory ac , i have built my engine compartment to look stock and original, except for the inner fenders, does anyone know how low i can go and keep the ac??