|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-04-2003, 10:39 PM
|
#1 |
|
Registered User
Join Date: Jun 2000
Location: Chico, CA
Posts: 1,136
|
need another front end torque spec
I'm installing ball joints, both upper and lower, on my '69 half ton. The uppers are in and I'm going to install the lowers tomorrow, parts store had to order them. To separate the lower ball joints from the spindle I removed the arm that the outer tie rod attaches to to make it easier on myself. What should the bolts that hold that arm to the spindle be torqued to?
__________________
My engine is stock... trust me ;o) |
|
|
|
04-05-2003, 11:15 AM
|
#2 |
|
Registered User
Join Date: Jun 2000
Location: Chico, CA
Posts: 1,136
|
ttt
__________________
My engine is stock... trust me ;o) |
|
|
|
|
04-05-2003, 12:29 PM
|
#3 |
|
faster, faster, faster
Join Date: Dec 2001
Location: Houston ,Texas ,USA
Posts: 1,354
|
25ft lbs I do believe, and the lower ball joints are 75ft lbs
__________________
I'm going to Law School, wanna debate? It's good practice. |
|
|
|
|
04-05-2003, 12:54 PM
|
#4 |
|
Registered User
Join Date: Jun 2000
Location: Chico, CA
Posts: 1,136
|
25...... thats it?!?!? I was thinking more along the lines of 60+ ft. lbs.
__________________
My engine is stock... trust me ;o) |
|
|
|
|
04-05-2003, 03:18 PM
|
#5 |
|
Gotta Startem Early
Join Date: Oct 2001
Location: Amarillo, TX, USA
Posts: 364
|
What size are the bolts?
__________________
67 SWB In Progress, one piece at a time, maybe 3 years I will be finished |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
