|
Re: Little Body Work on the Blazer/Tub
VT, along the lines of the welding your doing. Are you using Gas? What flow rate do you use for the gas? CUft/HR? I just upgraded from flux wire to gas and I'm experimenting with the settings and would like to know if I'm in the ball park. I know it all depends on the type of welder, wire feed speed etc. I'm using a HF Chicago MIG. Be interesting to know what others are doing.
Just some general info on what works for you would be great, Thanks
__________________
'71  Jimmy, 350, SM465, NP205, 2in Tuff Country lift, 33s on rallies, TBI, softtop and hardtop
"If life was fair you'd be able to afford one of each and a garage large enough to house them all."
Last edited by 71jimmy; 09-18-2009 at 06:01 PM.
Reason: found answer
|
09-18-2009, 01:31 PM
Hybrid Mode
