![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Nov 2008
Location: Cleveland, OH
Posts: 592
|
Disc brake steering rack question
Does anyone know the approximate difference between the angle on a drum brake steering rack vs. a disc brake steering rack for the tie rod ends? If anyone has both, could they try and measure it with a protractor or any other means? I threw out a 72 disc brake rack not knowing they were any different than a 70 drum brake rack. I am just going to fabricate a replica or modify my '70.
Thanks |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: May 2006
Location: Jonesboro, AR
Posts: 916
|
Re: Disc brake steering rack question
If you're talking about the center link, they are dimensionally the same except for the taper holes for the tie rod ends. I don't know if they are a different taper or if they are reamed out bigger.
You can use inner tie rods for 70, an adapter type adjuster and outers for a 72. CPP sells these: |
![]() |
![]() |
![]() |
#3 |
Senior Member
![]() Join Date: Sep 2007
Location: Albuquerque NM
Posts: 7,848
|
Re: Disc brake steering rack question
I found it was cheaper just to replace both inner and outer tie rods rather than go with the sleeve adaptor. but then I swapped out my center link too. I didnt see any difference at all, but then I didnt think to look at the taper in the inner tie rod mount locations so I bet thats the difference.
__________________
1967custom |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|