|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-02-2003, 02:04 PM
|
#1 |
|
Registered User
Join Date: Jan 2003
Location: San Diego, CA
Posts: 98
|
WTB: 1" or 1 1/2" lowering block for coil spring axle
Does anyone have a set of lowering blocks for a coil spring rear end laying around? Now that I have the axles I need to lower the back end so I can get ready for my C-Notch.
Cheers, Jay
__________________
67 Fleetside Shortie, small window, slip & slide tranny Upgrades--small block, tilt column, disc 5 lug conversion (front and rear), Future Projects--suburban gas tank under the bed, rear roll pan, better gas mileage (currently about 6-10 MPG) |
|
|
|
05-03-2003, 07:44 AM
|
#2 |
|
Registered User
Join Date: Dec 1999
Location: BRADENTON FLA
Posts: 3,269
|
How low are you planning to go in the rear? I can make the blocks with the proper degree built in for coil spring rears here in Fl and have notch kits, adj panhard bars and drop coils in Ca to save you on shipping cost and Ca state taxes.
__________________
Rest in Peace Ed. Thanks for all the good times. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
