Project: Recycle

[SCOTI]

Originally Posted by lolife99

It's just carbon steel.
I was going to have a buddy tack weld it in place from the bottom,...
and then finish weld it from the top.
I wanted something thicker than sheet metal, so I could tap the holes and use stainless machine screws instead of sheet metal screws.

Similar plan here. I'll use a steel backing plate w/SS machine screws to secure the filler in place.

I actually considered doing a little from each of my choices from the previous pics (weld in a flat piece of steel across multiple floor runners beveling the edges between to match the factory & simply mount the filler in the center).

I figured if my 1st attempt didn't work out, it's simply a matter of cutting it out @ welding in the flat piece.