Scott's hotrods shop truck - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jephs422 · 05-14-2010, 07:50 PM

pretty sure the last thing I need to do is post a bunch of pics on how to take out the old crossmember, so we;ll skip that part!

OK, she's about ready to go....

New unit is rolled into place. The guys ended up using a big pipe clamp to squeeze the frame a bit. makes it easier.

a few bolts here, a few bolts there.

These c-channel pieces really make a big difference when it comes to stiffening the frame up.

And we're just about done.

Stay tuned till Monday. The brakes, the shocks, and the notches will be in by then.

05-14-2010, 07:50 PM	#11
jephs422 Registered User Join Date: Jun 2008 Location: Oxnard CA Posts: 301	Re: Scott's Hotrods Bolt in IFS install.... pretty sure the last thing I need to do is post a bunch of pics on how to take out the old crossmember, so we;ll skip that part! OK, she's about ready to go.... New unit is rolled into place. The guys ended up using a big pipe clamp to squeeze the frame a bit. makes it easier. a few bolts here, a few bolts there. These c-channel pieces really make a big difference when it comes to stiffening the frame up. And we're just about done. Stay tuned till Monday. The brakes, the shocks, and the notches will be in by then. __________________ Jeff Savaglio Scott's Hotrods Oxnard CA 93030

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.