65Custom Build Thread

[65Custom]

Originally Posted by Alan's Classic

Very nice work!

Thanks

I'm making some progress it is slow going but none the less progress. I really don't recommend doing what you see in these pics unless you do a good bit of studying

Made my cuts, my first mistake as I should have cut the replacement part open first in my opinion I would have known a little more about what was behind it all

Cut the spot welds that I could reach had to drill the ones where the dash was, which caused some frustration but not too much

Here I was having some trouble getting the part out because of the sandwiched metal between the inside and outside panel, it took me awhile to figure out what was holding that part in place

After I got it all out and ready for the new part to go back in place

Cut out the replacement and then I could see what I should have seen before I started on the endeavor