|
07-02-2010, 02:37 AM
|
#1 |
|
Registered User
Join Date: Aug 2009
Location: Red Deer, Alberta
Posts: 190
|
Wheel alignment
Do I need a wheel alignment after the installation of drop spindles. No other adjustments were made to the front end, no lowering springs, just 2.5 inch drop spindles.
 Thanks.
__________________
"If you need to tell everyone how good you are - your probably not" |
|
|
|
07-02-2010, 06:19 AM
|
#2 | |
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: Wheel alignment
I would, there is the possibility of slight differences in the machining of the parts. It doesn't take much to be off enough to cause tire wear, or even drifting/pulling.
__________________
You can review the site's rules here. Quote:
Bad planning on your part does not necessarily constitute an instant emergency on my part.... The great thing about being a pessimist is that you are either pleasantly surprised or right. 
|
|
|
|
|
|
07-02-2010, 04:53 PM
|
#3 |
|
Active Member
Join Date: Feb 2008
Location: Los Angles CA
Posts: 136
|
Re: Wheel alignment
You should get the truck realigned. When working on new kits I like to start with 5 different trucks, align them before and after. I compare the adjustments required before making the final part. What I correct for is the deviation I see from Chevrolet, Ford, etc. They do not build the trucks that well in the first place. So yes, get it aligned when your done.
Danny Nix CPP |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
