|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-10-2010, 03:20 PM
|
#1 |
|
Registered User
Join Date: Aug 2009
Location: PA
Posts: 883
|
how to mount bedsides with no bed floor?
ive seen some of you bagged guys hve ur besides attached with no floor, im trying to take out whats left of my floor. but need ideas to mount the bed sides. thanks.
|
|
|
|
10-10-2010, 03:54 PM
|
#2 |
|
Registered User
Join Date: Jun 2010
Location: Pittsburgh PA
Posts: 686
|
Re: how to mount bedsides with no bed floor?
Are you talking about inner or outer bedside? If you talking about the outer, there are multiple ways. With the floor gone, you can leave the inner sides with the front and the very back lower rear connected then just spot weld the bedside on. you can make a inner structure out of square tubing and mount the bedsides, then cover with a fiberglass cover. ect. your imagination is the limit.
__________________
86 Suburban 2WD = rolled it and totaled it  83 LWB STD Cab 4x4 = went to the scrapper. Was my baby. 84 Suburban 2WD = stripped it/ scrapped it 81 8 foot bed made into a trailer 86 Suburban going to be made into a trailer 91 Suburban 4x4 = that's my baby 00 S10 Xtreme STD Cab 01 S10 ZR2 |
|
|
|
|
10-10-2010, 04:37 PM
|
#3 |
|
Registered User
Join Date: Aug 2009
Location: PA
Posts: 883
|
Re: how to mount bedsides with no bed floor?
any picures?
|
|
|
|
|
10-10-2010, 07:17 PM
|
#4 | |
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: how to mount bedsides with no bed floor?
Mine was like that many years ago. It was a LWB 4x4 and all I did was make crossmembers out of square tubing. It was a lifted truck used for pulling and weekend mudding and this made cleaning much easier. The inner wheel wells were there, so from the outside you couldn't even tell that the floor was gone, unless the tonneau cover was off...then the sun shined on the ground under the bed.
__________________
You can review the site's rules here. Quote:
Bad planning on your part does not necessarily constitute an instant emergency on my part.... The great thing about being a pessimist is that you are either pleasantly surprised or right. 
|
|
|
|
|
|
10-11-2010, 11:16 PM
|
#5 |
|
Registered User
Join Date: Aug 2009
Location: PA
Posts: 883
|
Re: how to mount bedsides with no bed floor?
thats makes sense, im gonna start some sketches.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
