|
12-14-2010, 11:36 PM
|
#11 |
|
I had a V-8
Join Date: May 2003
Location: Phoenix AZ
Posts: 1,116
|
Re: Berthas Build
Well, I guess if it came from the factory that way it should work. I never found a diagram showing a belt routing with those components, so when I was engineering mine (from scratch--no diagram) I did not like the 90* of wrap that I was getting on the compressor, but after seeing this I guess it is ok. I just like to see more, personally.
Before you do anything, hang the water inlet on the motor and make sure your tensioner mount/plate is going to fit you frame rail. I bet there is going to be interference. I hope not, but I think mine got all over the frame rail. Thus the reason I still have one....
__________________
1972 K20 Suburban, 5.9L Cummins, Banks Power Pack, NV4500HD, NP205, H.A.D., D60/14FF ARB Link To Build: HERE. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode