|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-27-2003, 03:35 PM
|
#1 |
|
Well, Whoop-dee-do!
 
Join Date: Mar 2003
Location: Easton, Mo. pop.- me & scarcely a few others
Posts: 2,302
|
235 Oil Galley Plug Question???
I am getting ready to install a '58 235 eng in a '52 truck. I started putting all the oil galley plugs in without any problems until I looked at the lower left galley on the rear of the block. It's the one that runs straight thru front to rear. It has two separate threaded sizes, 3/8" at the surface & 1/4" in a little deeper. Do I leave the 1/4" open & plug the 3/8" only? It looks like the 1/4" hole would block off an oil passage if I plugged it. I wasn't the one to take it apart (3 years ago) so I don't know for sure. Thanks in advance for the help.
|
|
|
|
06-27-2003, 09:08 PM
|
#2 |
|
Registered User
Join Date: Mar 2003
Location: Newport NH
Posts: 216
|
Jeff when you have a question on the "old" stuff, try going over to www.stovebolt.com Those guy's really know their stuff on the stock stuff.
__________________
you laugh at me cause i'm different ; i laugh at you cause you're the same 
|
|
|
|
|
06-27-2003, 09:11 PM
|
#3 |
|
Well, Whoop-dee-do!
Join Date: Mar 2003
Location: Easton, Mo. pop.- me & scarcely a few others
Posts: 2,302
|
Yep. Have the same posted there too.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
