|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-25-2011, 03:29 PM
|
#1 |
|
Registered User
 Join Date: Apr 2010
Location: Sutton, WV
Posts: 340
|
How do I remove coil springs with crossmember removed from truck
I have the whole cross member removed and i need to know what to do to remove the coil springs without tearing off my head. Thanks. Wayne
|
|
|
|
01-25-2011, 03:38 PM
|
#2 |
|
Registered User
Join Date: May 2005
Location: Beaverton, OR
Posts: 3,728
|
Re: How do I remove coil springs with crossmember removed from truck
Are you replacing the ball joints?
I took the castle nut off the bottom ball joint, flipped the nut over and put it back on until flush with the bolt. Then I smacked it a few times with a BFH and POP! Then you can loosen the ubolts and castle nut until the lower arm pops free. Most of the tension is out at the point, so it won't go flying off.
__________________
New Project: 1966 LWB C20 Plans: 1/2 ton conversion Dropmember front Dropmember rear Corvette discs Restored raised bed http://67-72chevytrucks.com/vboard/s....php?p=4295210 |
|
|
|
|
01-25-2011, 05:05 PM
|
#3 |
|
Registered User
Join Date: Jul 2010
Location: memphis
Posts: 2,537
|
Re: How do I remove coil springs with crossmember removed from truck
Rent a coil spring compresor from tha parts store..that is tha safe way to do if you wanna use them over.
|
|
|
|
|
01-25-2011, 07:28 PM
|
#4 | |
|
sharp as a marble
Join Date: Jan 2007
Location: atlantic beach,florida
Posts: 1,082
|
Re: How do I remove coil springs with crossmember removed from truck
Figure out what your head is worth, THEN rent/borrow a GOOD spring compressor. If you do not intend to reuse the spring, I would cut them into pieces with a torch.
Quote:
|
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
