![]() |
![]() |
#1 |
Registered User
Join Date: Jan 2011
Location: Redmond, OR
Posts: 759
|
Eaton axle vent?
OK, just looked at my rear axle to see if I could find the code to determine the gear ratio - no luck (68 C20, Eaton rear). I found a hole on the top, driver's side that is open into the axle tube.
Should there be a vent attached there? Heading out for a bit, but will check further later.
__________________
68 Chev C20- son has it now 83 K20 - bought from son 70 C20 - in progress Last edited by dmack91; 02-01-2011 at 06:26 PM. Reason: correction |
![]() |
![]() |
![]() |
#2 |
Packrat
Join Date: May 2008
Location: Central Iowa
Posts: 459
|
Re: Eaton axle vent?
yes, that's where the vent should be...
__________________
gone: --'07 Tahoe LTZ 4WD --'68 Firebird 400 Convertible gone: --'72 Chevy K20 |
![]() |
![]() |
![]() |
#3 |
What?
Join Date: Jun 2007
Location: Southern California
Posts: 7,617
|
Re: Eaton axle vent?
Mine just has a cap vent, no hose like my D44 up front.
__________________
Chris 1968 K20 Suburban 1972 K10 LWB PU |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Jan 2011
Location: Redmond, OR
Posts: 759
|
Re: Eaton axle vent?
Thanks, I will clean it out and hope there are still threads in it.
__________________
68 Chev C20- son has it now 83 K20 - bought from son 70 C20 - in progress |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|