Has anyone done this yet - The 1947 - Present Chevrolet & GMC Truck Message Board Network

CHROMAHOLIC · 02-23-2011, 06:59 PM

we stretch and customize tractor trailers where I work....we cut one frame rail on a 45 one way then cut the other on a 45 the opposite way. We install pieces in the frame that extend past the cuts a couple of feet and bolt in another crossmember if needed...

Please note that you must be a supporting member to post personal advertisements. Please consider supporting the forum by subscribing. Further information on the subscription levels available are located here

If you need any further assistance with that please contact any Admin for help.

02-23-2011, 06:59 PM	#5
CHROMAHOLIC Registered User Join Date: May 2009 Location: Ontario, Canada Posts: 795	Re: Has anyone done this yet we stretch and customize tractor trailers where I work....we cut one frame rail on a 45 one way then cut the other on a 45 the opposite way. We install pieces in the frame that extend past the cuts a couple of feet and bolt in another crossmember if needed... Please note that you must be a supporting member to post personal advertisements. Please consider supporting the forum by subscribing. Further information on the subscription levels available are located here If you need any further assistance with that please contact any Admin for help. Last edited by joe231; 02-23-2011 at 09:59 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.