![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Sep 2010
Location: Langdon, Ab
Posts: 348
|
Exhaust through crossmember?
Has anyone cut holes in the steady bearing/rear arm crossmember where the slots are cut for the E-cables & run the exhaust through it? I think if I did that I could run my pipes from front to back without ever dropping below the frame.
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Jul 2007
Location: Yardville, NJ
Posts: 144
|
Re: Exhaust through crossmember?
it has been done quite a few times if you search the right keywords. here's one that comes to mind, scroll down to post 120 or so.
http://67-72chevytrucks.com/vboard/s...=226302&page=5 |
![]() |
![]() |
![]() |
#3 |
Senior Member
Join Date: Jan 2005
Location: SUNNY WARM BIKE RIDING COTTONWOOD ARIZONA
Posts: 2,097
|
Re: Exhaust through crossmember?
yep my short bed BB truck had holes all the way back and it was tucked completely up behind the frame. couldnt see anything but the very bottom of the header.....
there are some super SLICK/SICK TUBULAR cross members that ive seen on here that replace all the stock cross members.. im sure they are $$$$$ but man are they sweet.... |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Sep 2010
Location: Langdon, Ab
Posts: 348
|
Re: Exhaust through crossmember?
Thanks Dyrt, thats exactly what I was thinking. I'll do some measuring tomorrow.
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|