Starting my first build - 1966 C10

[Scot_Douglas]

Minor update:

The IRS needed some clearance for the upper arms, so I cut down the fenderwells from the stepside box and "mini-tubbed" the inside of the box. If I ever find a 2WD AX-15, this will let me run 305/45R18 tires.


The tub is 4 1/2" deep and is the same width as the outside board on the stepside box; it should make for a clean look. I'll weld it from the outside in the fenderwell and use seam sealer to blend it at the box for (hopefully) a stock look.



Rear shock mounts in, swaybar location mocked up and initial positioning of the fuel tank.