![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#51 |
Senior Member
![]() Join Date: Feb 2010
Location: Maumelle, AR
Posts: 478
|
Re: How to drop the front end? How much?
Why do you think it is too low? What sort of trouble does it give you?
|
![]() |
![]() |
![]() |
#52 |
Registered User
Join Date: Jan 2010
Location: Roanoke, Tx.
Posts: 1,561
|
Re: How to drop the front end? How much?
I did not mean to steel this post. My 87 sit 3 inches higher in the back then in the front.. The front tires hit the top of the inner fender some times. Thanks
|
![]() |
![]() |
![]() |
#53 |
Senior Member
![]() Join Date: Feb 2010
Location: Maumelle, AR
Posts: 478
|
Re: How to drop the front end? How much?
No worries about stealing the thread. You've provided good information. Thanks.
|
![]() |
![]() |
![]() |
#54 |
Registered User
Join Date: Apr 2011
Location: bowling green, ky
Posts: 439
|
Re: How to drop the front end? How much?
will 94. 1500 p/u front spring fit on 87 silverado.... I thought they did but everything I see now is 88-96,,,, if I cut them how low can I go befor I have to get lower shocks...
Posted via Mobile Device |
![]() |
![]() |
![]() |
#55 |
Senior Member
![]() Join Date: Feb 2010
Location: Maumelle, AR
Posts: 478
|
Re: How to drop the front end? How much?
Why would you not cut the springs for the 87? Just wondering...
|
![]() |
![]() |
![]() |
#56 |
Registered User
Join Date: Apr 2011
Location: bowling green, ky
Posts: 439
|
Re: How to drop the front end? How much?
So I can have a back up plan if I. Change my mind...
Posted via Mobile Device |
![]() |
![]() |
![]() |
#57 |
Senior Member
![]() Join Date: Feb 2010
Location: Maumelle, AR
Posts: 478
|
Re: How to drop the front end? How much?
So, after crushing and otherwise damaging my control arms that I spent so much time and effort in, I was put in a position where I needed some replacements. Instead of getting some other stockers I decided to go with tubular ones. And since I was needing to replace the arms anyway I decided to get drop arms instead of using drop spindles. So it looks like 3" drop arms and 2" drop springs. Will this cause me any massive problems? I have the stock spindles all cleaned up nice and freshly painted...
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|